![]() ![]() ![]() What does this button do? Any time you hit ‘play’ in Logic, it’s recording MIDI. Check the Capture Recording box, click ok, and now you will have a new recording button with a halo around it. Right-click (ctrl-click) on the transport and select Customize Control Bar and Display. Control Surface SupportĬapture recording is a deceptively simple feature, but first you must enable it. Even if you only use the Easy View, Logic has one of the nicest implementations of external controller interfacing on the market. The manual is here and contains a good amount of helpful information. Logic’s Controller Assignments is fantastic. Or you can just use the ‘Easy View’ and never think about it! OSC specs depend on the device that you’re using, check the device/program manual for more information. It may seem confusing at first, but it’s not that difficult to figure out with some experimenting. If you want a good start to some of the midi spec, I suggest starting here. It also supports value feedback, including support for outputting specific data for controller displays! Logic supports min/max and inversion, value scaling, various data interpretations for signed formats and different modes for applying the incoming data to thec urrent value. You can input the data in Hex format for Midi and paths for OSC. When using MIDI or OSC, you have full control over exactly what data is used from which device. Playhead/markers/zoom/any AU parameter/fader/pan/track/transport/key command/etc… You can even assign MIDI/OSC to typing letters! There’s a wide variety of modes that let you select to control nearly everything in Logic. The parameters view is where the real fun happens! You have total control over the midi data, or osc data input, what it controls and how. Modes can be switched via midi input when a controller assignment class is set to ‘Mode Change’. ![]() You can place these mappings in their appropriate ‘zone’ and ‘mode’ to make them easier to navigate in the future. Like you may have an ‘Encoder’ zone, with shift a shift mode. Zones and Modes are an organizational tool to allow you to layout different ‘layers’ of the controller. Fast and easy.Īnd then there’s the ‘Expert View’, which is where the real fun is. Move the control on screen, hit command-L, move the knob on your controller. There’s an ‘Easy View’ method that makes simple CC mapping easy. Logic’s controller mapping is very powerful, yet very simple when necessary.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |